Why the South Tower fell first
The South Tower collapsed first because, in NIST’s reconstruction, it had suffered greater damage to its core and sustained early, persistent fires beside that damage. Those fires heated steel where aircraft debris had extensively dislodged its protective insulation. The combination exhausted the damaged structure’s ability to carry and redistribute loads sooner than in the North Tower. NIST, p. 176.
The North Tower stood for 102 minutes after impact; the South Tower stood for 56. The difference depended on where the fires acted on the damage and which load paths remained, as well as how long each building burned. NIST, pp. 148–153.
Watch the explanation
See how the core, floors and perimeter shared the load, and how damage changed those paths.
How the towers kept standing after impact
The towers were connected structural systems. Columns in the central core and around the perimeter carried gravity loads. Floor assemblies linked those systems, and a framework near the roof called the hat truss provided another route for transferring loads. When columns were severed, surviving members took over part of their work. Both towers remained standing after the aircraft impacts. NIST, p. 148.
Photographs showed damage to the outside columns, while NIST used simulations to reconstruct the core’s condition. The comparison identified more severe core damage in the South Tower, including a heavily loaded corner column. Investigators modeled those interior conditions; they did not have photographs of every failed component. NIST, pp. 176, 182–183.
Why the steel did not have to melt
Steel can lose strength and stiffness as it heats while remaining solid. In the towers, the initial jet-fuel fires lasted only a few minutes; burning building contents sustained the subsequent fires. Loss of insulation exposed parts of the already damaged structure to faster heating. NIST, pp. 183–185.
In NIST’s probable South Tower sequence, weakened east-side floors sagged. Floor connections that remained attached transmitted an inward pull to the perimeter columns. Those heated columns bowed inward and eventually became unable to carry their loads. Weight shifted again, this time toward adjacent walls and a core that had also been weakened. NIST, pp. 151–152.
NIST found that inward bowing alone was insufficient to explain collapse initiation; the core also had to be substantially weakened. Attached floors supplied the inward pull before global instability. The investigation did not find that floors successively disconnecting initiated a simple “pancake” collapse. NIST, pp. 148, 184–185; investigation FAQs.
Two different fire-and-damage sequences
In the South Tower, severe core damage and early east-side fires coincided in a vulnerable region. In the North Tower, fires progressed toward the south, and the interval depended on the time required to weaken the core and the south-side structure. The two buildings did not run through one identical sequence at different speeds. NIST, pp. 149–153, 176.
NIST reconstructed the events leading to collapse initiation. Its simulation did not cover the entire subsequent descent to the ground, a limit that also applies when using the report for explanatory animations. NIST FAQ 10.
Impact damage reduced the available load paths, and loss of insulation accelerated heating. As floors and columns weakened, loads shifted until the remaining structure could no longer carry them.
We remember the people who lost their lives and the families and communities affected.
The source record
NIST NCSTAR 1: Final Report on the Collapse of the World Trade Center Towers
2005 · Printed pp. 148–153, 176 and 182–185; PDF pp. 198–203, 226 and 232–235. These are probable reconstructed sequences, supported by observations.
NIST: WTC Towers Investigation FAQs
Questions 10–11 and 17: investigation scope, combined impact/fire mechanism and collapse initiation.
Research checked September 21, 2026. Illustrative episode images are not primary evidence.
